Click here to go to UPSCALE home page.
Click here to go to I Year Lab home page.
You can jump directly to a section of this specification sheet by selecting an item below and clicking the left button.
X-Y Recorder
Manufacturer: Riken Denshi
Model: F-3F
Description
Small, lightweight plotter with X-Y recording capabilities.
Specifications
Input sensitivity | 12 ranges between 0.1 mV/cm and 20 V/cm. |
Input Impedence | 10 M Ohms fixed on all ranges. |
Accuracy | Within ±0.2 % |
Power requirement | AC V 50/60 Hz, 17 W |
Click here to go to the top of this page.
Operating Instructions
- Set the ZERO-MEAS switch to ZERO.
- Set the pen lift switch UP and turn POWER switch ON.
- Connect the Input circuit to the input terminals (grounding assures stable recording).
- Adjust Gain and Damping of the Amplifier as requirfed.
- Adjust response speed of X and Y plotting (Apply same voltage at the same time to X and Y, then gradually increase/decrease the voltage until desired response speed is obtained).
Caution!
For accurate measurements:- Do not operate recorder for long periods of time with high oscillation or gain.
- Avoid humidity and dust (cover recorder when not in use).
Click here to go to the top of this page.
keywords: pen recorder, frequency measurement device, time measurement device, electrical measurement device, voltage measurement device, voltmeter.
Document created July 17, 1996. Original author: Jaime Espinoza.
Last updated 07/26/96. Revised by David Harrison.