Description
One watt sine wave signal generator with
frequency and amplitude selectors.
Frequency range | 20 cps to 40 kc |
---|---|
Frequency response | ±1 db entire frequency range when working into rated load (reference 1 kc) |
Frequency stability | Line voltage variations of ±10% cause negligible shift in output frequency |
Power output | 1 watt or 24.5 volts RMS (34.7) into a 600 ohm load |
Amplitude range | 1 to 100% of 24.5 volts RMS |
Distortion | Less than 1%, 20 cps to 20 kc; less than 2%, 20 kc to 40 kc when working into rated load or higher impedance. |
Calibration accuracy | ±2% including calibration error, warm up, and changes due to aging of components. |
Internal impedance | Approximately 75 ohms from 20 cps to 20 kc |
Hum and noise | At least 66 db below rated output (less than 0.05% of rated output) |
Note: The black plug is the ground and is wired to one of the red plugs so that either can be used as a ground reference.
Click here to go to the top of this page.